Measurement Guide

Window Measurement Guide
Window measurement banner

Prepare Your Tools

  • Tape measure or laser measure (for measuring distances)
  • Ladder or step stool (for reaching high places)
  • Notepad and pen (for recording measurements, You can download our measurement spreadsheet, which is more convenient.)

Before We Start

  • Document your measurements using the width by height format (W x H).
  • Make precise measurements to the nearest 1/8 inch (or 0.1 cm) at the locations indicated on the illustrations. Do not round down.
  • Take into consideration any obstructions such as doorknobs, deadbolts, or molding that might obstruct the installation. In such cases, spacer blocks or extension brackets are available to assist in extending the shade to avoid protrusions.
  • For inside mount, order the exact opening size with no deductions. During production, the factory will apply a small deduction of approximately 0.2 inches (0.5 cm) to ensure a safe and proper installation.
  • For outside mount, we will not make any deductions.

ROLLER SHADES

Shangri-la, zebra blinds, fire protection, and printed Monet are the same as roller blinds.

Choose a Mount Type

Measure the window depth. If the minimum depth requirements for inside mount is achieved, decide whether you want to do inside mount or outside mount.

Inside Mount

  1. Measure Width
    Measure the width at the top, middle, and bottom of the window frame. Use the smallest measurement as the ordering width. The factory will make a small deduction of 0.2 inches.
  2. Measure Height
    Measure the height on the left, center, and right. Use the largest measurement as the ordering height.
Inside mount measurement diagram

Outside Mount

  1. Measure Width
    Measure the width of the area you want to cover. It's recommended to add 2-3 inches to reduce light infiltration.
  2. Measure Height
    Measure from where you want to mount the shade down to where you want it to end.
Outside mount measurement diagram

Installation Depth Requirements

Options Inside Mount - Minimum Depth Inside Mount - Flush
Single Roller - No Valance 2 5⁄8 in (6.5cm) 2 5⁄8 in (6.5cm)
Single Roller - Designer White Valance 2 3/8 in (6cm) 3 9/16 in (9cm)
Double Roller - Designer White Valance 5 1/8 in (13cm) 5 2/8 in (13cm)
Depth measurement diagram